In more than 30 years Dbilas is a producer of double carburetor systems and Flowtec – intake manifolds. The dbilas dynamic Flowtec – intake manifold has been developed and constructed with the most advanced computer aided technology. Using the air oscillations produced by naturally aspirated engine intake flow into the cylinders producing a boost effect on the intake charge. These air oscillations improve the engine cylinder filling speed on lower and upper engine rev range.
This results in a very even torque curve, the optimization of the intake manifold within the engine produces a responsive power to fulfill the expectations of a sports oriented driver without the standard torque being compromised.
The development was further enhanced with the importance attached to the look and a sporty design. When installed to maximize the power out put software should be exchanged to optimize the air to fuel ratio, ignition, engine speed and load sensitivity. The engine meets the newest emissions regulations set by the German TÜV. The CO2 emissions measured over the driving cycle is as standard and the fuel consumption has been effected and the environmental impact is as before. All Flowtec – inlet manifolds are pre-mounted and ready to be installed. The kit contains fitting instructions, inlet manifold and all necessary small parts.